Fitting the stair tread nosing.
Johnsonite stair treads maintenance.
Johnsonite stair treads nosings risers stringers and adhesives must be site conditioned at room temperature for 48 hours prior to during and after installation.
Maintenance 72 hours after installation is completed initial maintenance procedures must be implemented in accordance with manufacturer s requirements.
Johnsonite stair treads nosings and risers must be trimmed to proper size and dry laid prior to the application of adhesive.
Johnsonite safe t first rubber stair treads september 2015 page 2 of 2 safe t first rubber stair tread ps 091015 6.
Daily cleaning is recommended.
A minimum temperature of 55 f 13 c must.
Safety happiness productivity.
Back of the tread must be cleaned with denatured alcohol to ensure proper adhesion.
Since each step on a staircase can vary slightly in width depth and squareness tarkett recommends scribing each tread nosing and riser to ensure proper fit on the step.
Refer to johnsonite rubber stair tread maintenance instructions for complete.
Room temperature must be maintained between 65 and 85 f 18 and 29 c with hvac system operating.
It is very important to clean the stair treads at a frequency consistent with the amount and type of traffic and soil conditions.
Thoroughly sweep or vacuum the flooring to remove all loose dirt and grit.
Prepare a cleaning solution using one of the recommended ph.
Rubber and vinyl stair treads 1.
The nose of the tread must fit tightly against the face of the stair riser or nosing.
Johnsonite stair treads must be trimmed to fit for both width and depth of the stair step and dry laid on each step prior to adhesive tape application and installation.